No products
Prices are tax included
Viewed products
-
Signalink SLCAB-RJ4...
The Signalink SLCABRJ4 radio interface cable...
New products
-
-
Pack of 4 N adapters with carrying case PASSION RADIO
26,42 € tax incl. -
Pack of 6 BNC adapters with carrying case PASSION RADIO
25,12 € tax incl. -
Pack of 5 UHF adapters with carrying case PASSION RADIO
25,30 € tax incl.
-
Book in french "Citizen-Band, la CB ce réseau oublié"
18,00 € -10% 20,00 €
Signalink SLCAB-RJ4 radio cable micro RJ45 socket for Alinco Icom Kenwood Yaesu Anytone
Read the reviewThe Signalink SLCABRJ4 radio interface cable can be used with the Signalink USB sound card and with practically all Alinco , ICOM, Kenwood, Yaesu radios and Anytone AT-578UV (V1 et V2). This radio cable is compatible with virtually all radios that have an 8-pin RJ-45 type microphone plug . This includes, but is not limited to, the radios listed below.
The jumper modules compatible with this cable bear the reference: SLMODR4I, SLMODR4K , SLMODR4Y .
If in doubt, check the guide below by searching the PDF download document to find the correct cable and jumper module reference for your radio.
Supplied with: 1 Signalink SLCAB-RJ4 radio cable.
Download
Guide in French to choose the right radio cable and jumper according to the brand and model of the radio used. 177.6k
Guide in English to choose the right radio cable and jumper according to the brand and model of the radio used. 666.13k
Data sheet
Alinco (SLMODR4I)
| DR-605E |
| DR-605T |
| DR-735E |
| TK-2100 |
Icom (SLMODR4I)
| IC-207H |
| IC-208H |
| IC-281A |
| IC-281E |
| IC-281H |
| IC-704 |
| IC-706 |
| IC-706MKII |
| IC-706MKIIG |
| IC-2000 |
| IC-2100H |
| IC-2200H |
| IC-2300H |
| IC-2700 |
| IC-2720H |
| IC-2730A |
| IC-2730E |
| IC-2800 |
| IC-2820 |
| IC-7000 |
| IC-7100 |
| IC-F121 |
| IC-V8000 |
| ID-800H |
| ID-880 |
| ID-4100A |
| ID-4100E |
| ID-5100A |
| ID-5100E |
Kenwood (SLMODR4K)
| TK-90 |
| TK-863G |
| TK-7102H |
| TK-7108HM |
| TK-7108M |
| TK-7160E |
| TK-7160HM |
| TK-7160M |
| TK-7162E |
| TK-7180E |
| TK-7189E |
| TK-8108HM |
| TK-8108M |
| TK-8160E |
| TK-8160M |
| TK-8162E |
| TK-8180E |
| TK-8189 |
| TM-251 |
| TM-255 |
| TM-261 |
| TM-271 ** |
| TM-271A ** |
| TM-281 |
| TM-451 |
| TM-455 |
| TM-461 |
| TM-481A |
| TM-641 |
| TM-642 |
| TM-732 |
| TM-733A |
| TM-741 |
| TM-742 |
| TM-941 |
| TM-942 |
| TM-D700 |
| TM-D700A |
| TM-D710 |
| TM-D710A |
| TM-D710E |
| TM-D710G |
| TM-D710GA |
| TM-G707 |
| TM-V7A |
| TM-V71A |
| TM-V71E |
| TM-V708 |
| TS-480HX |
| TS-480SAT |
Yaesu (SLMODR4Y)
| FT-450 |
| FT-600 |
| FT-817 |
| FT-817ND |
| FT-858 |
| FT-857D |
| FT-898 |
| FT-897D |
| FT-900 |
| FT-992 |
| FT-991A |
Anytone
AT-578UV V1 and V2
SignaLink jumper settings for the AT578 :
G - 8
PTT - 1 (via a resistor from 1.5Kohm to 2.2Kohm, see PTT** note below
MIC - 6
SPK - Do not install this jumper wire, see SPK*** note below
PTT**: A 1.5Kohm to 2.2Kohm resistor is required instead of the normal jumper wire, otherwise you may damage the radio. Use only a 1/4 watt resistor, as it has the correct size wires to connect to the SignaLink jumper, a larger resistor will damage the plug. Also as noted on http://members.optuszoo.com.au/jason.reilly1/578mods.htm#Microphone, the radio must have VOX detection enabled or the PTT will not work.
SPK***: The microphone jack on this radio uses differential audio which cannot be used with Signalink, otherwise you will damage the radio's audio amplifier. Instead, attach the supplied audio cable between the SignaLink's SPKR jack and one of the radio's external speaker jacks.
Additional or similar equipment
RJ45 Ethernet Adapter Cable - USB 2.0
Ethernet adapter cable to USB 2.0.Comes with: 1 Vention USB 2.0 Ethernet adapter.
8,55 € tax incl.In stock7,13 €tax excl.
Yaesu table microphone M-70 with 8-pin & RJ45 connector + UP/DOWN touch
YAESU M-70 (ex. MD-100 A8X) desktop microphone for Yaesu HF equipment with 8-pin microphone plug or RJ45 with the 8-pin > RJ45 adapter included.Impedance 600 OhmsUP and DOWN buttons (only
145,00 € tax incl.In stock120,83 €tax excl.
Tigertronics Signalink USB radio interface and sound card
The Signalink USB radio interface from Tigertronics is a USB sound card that allows you to receive and transmit from a computer to practice digital modes such as SSTV, RTTY, Packet, PSK, ROS, FT8,
145,00 € tax incl.Out of stock, available within 1-2 months120,83 €tax excl.
Signalink SLCAB-8R micro 8-pin radio cord Alinco Elecraft Icom Kenwood Yaesu
The Signalink SLCAB8R radio interface cable can be used with the Signalink USB sound card and with virtually all Alinco, Elecraft, ICOM, Kenwood and Yaesu radios that have an 8-pin micro plug . This
34,90 € tax incl.In stock29,08 €tax excl.
Reviews
Conforme au cablage de mon tx aucun pb
Delivery Europe & Overseas
Stock and shipped from France
Product return
14 days to return, 2 warranty
Email support
Response within 24h to 72h
Secure payment
SSL, VISA, Mastercard, Paypal