Delivery can be delayed locally due to COVID, for fast delivery use only UPS, Fedex or DHL.
Reference: QO100-AMP-BOITIER-DXPATROL-9591
The DXpatrol 2400Mhz V2 amplifier is intended to be used with the DXPatrol transverter for QO-100, from version MK2.It allows to output 12W maximum from an input between 50mW and 100mW maximum.
Reference: QO100-DXPATROL-GPSDO-1081
DX Patrol's GPSDO (GPS Disciplined Oscillator) is made up of a GPS receiver (U-Blox 7N) and a 10 Mhz OCXO oscillator with pure sine wave and very high stability (0.05ppm), disciplined thanks to the
Reference: OCTAGON-SF8008-SINGLE-798
OCTAGON SF8008 DVB-S2X satellite receiver, operating with Linux, for 4K UHD E2 2160p H.265 TV reception.The tuner is equipped with the new standard DVB-S2X, a USB 3.0 port, a LAN port and H.265, HDMI
Reference: QO100-DXPATROL-CONVERTER2-922
The 10Ghz / 739Mhz Converter DXPatrol Pack with built-in 10Mhz stabilization for the Oscar 100 satellite allows you to listen to the 10Ghz from QO 100 satellite (Narrow NB transponder), directly on
Reference: QO100-F1OPA-UPCONVERTER-803
This 144/432Mhz mixer to the 2.4GHz band is intended to be used as a dedicated up-converter to traffic on the uplink of the QO-100 satellite. The included SAW filter allows system size reduction as
Reference: QO100-F1OPA-AMPLI2400-938
This power amplifier equipment with a gain of 30dB is intended to operate primarily with F1OPA's upconverter 144 / 432Mhz - 2400 MHz to traffic on the QO-100 satellite uplink with 100mW output (20dBm)
Reference: DXPATROL-QO100-BOITIER4-1084
Metal case for the DX Patrol 2.4 Ghz MK2 (V2) amplifier for activity on the QO-100 ham radio satellite.Supplied with: 1 metal box for 2.4 Ghz DX Patrol amplifier.
Reference: NOOELEC-100799-NOAA-1061
This SawBird + filter from Nooelec is specially designed to operate on the NOAA 137 Mhz frequency band and for NOAA weather satellite reception applications.It makes it possible to significantly
Reference: RF-Power8000-926
The RF-Power 8000 module is a 0.96-inch OLED wattmeter for power measurements from 1nW to 2W (with the use of optional attenuators), from -45dBm to -5dBm in nominal for the frequencies of 1 at 8000Mhz
Reference: NOOELEC-ANT-100817-PCB-958
Nooelec PCB Patch antenna for Inmarsat L-band application (Inmarsat AERO / STD-C) and satellites on 1550 Mhz. The antenna is delivered with female SMA connector soldered on the PCB.The antenna works
Reference: NOOELEC-100722-OUTERNET-467
This LNA and SAW filter from Nooelec is specially designed to operate on 1.5Ghz Outernet frequency band and for Inmarsat radio applications, covering from 1.50GHz to 1.58GHz. It significantly
Reference: FILTRE-SAW-QO100-F1OPA-824
This bandpass filter for the 2.4 Ghz (13cm) allows to reject the local oscillator and harmonics frequencies of the Up-Converter for QO-100 to get a clean signal on the satellite, with a max. input
Reference: OPA-BOITIER-941
This milled aluminum milled box is specially designed for the RF protection of PCBs from F1OPA Design: LNA VHF-UHF, Bias-T, 2.4Ghz amplifier, SAW 868Mhz filters, ADS-B, QO-100 2.4Ghz and HF LNA.Case
Reference: DXPATROL-QO100-BOITIER3-1083
Metal case for the DX Patrol transverter for QO-100, from CT1FFU.Comes with: 1 box to assemble for the DXPatrol MK3 or MK4 transverter version to choose below.
Reference: CABLE-RIPCORD-12V-8002
With the Ripcord USB power cable, you have the freedom to power anywhere you are any device in 5, 9 or 12V from a USB port of a laptop, from an external battery or from a smartphone/tablet (with OTG
Reference: QO100-OPA-BIAS-T1-760
This BT4G-based BIAS-TEE is used to power a LNA or a 10Ghz PLL LNB to receive the QO-100 / Es'Hail2 satellite.The BT4G covers the frequency bands from 30 MHz to 4 GHz. The +/- supply leads are
Reference: QO100-REMOTEQTH-BAGUE2-QRO-999
This adapter ring allows the POTY antenna tube to be easily inserted and properly held in place on the modified LNB head supplied in the pack RX for QO-100 from RemotheQTH only.Inner diameter: 22
Reference: QO100-LENTILLE2-HB9VQQ-1027
New high-performance version of the POTY antenna lens for optimized reception of the 10 Ghz downlink of the amateur satellite Oscar-100 (QO100) with an offset par f/D of 0.6 and D of 88cm.Directly
Reference: QO100-COUPLEUR-743
Combiner SAT / TV, this coupler allows to feed a LNB PLL head for QO-100, a protection box allows to use it outside.SAT input frequency: 950 - 2300 MhzTV / TNT input frequency: 5 - 790 MhzOutput
Reference: CABLE-COAXIAL-SMA-COUDE-1M-932
KSR195 low loss 50 ohm coaxial cable for use from 0 to 6Ghz, with angled SMA connector and straight SMA connector.Available lengths: 50cm, 1 or 2 metersConnector 1: SMA Male angledConnector 2: SMA
Reference: SPF5189Z-QO100-AL-LNA-833
This SPF5189Z LNA preamp improves reception performance from 50 Mhz to 4000 Mhz, based on SPF5189Z, with a noise factor of 0.6 dB and a maximum gain of approximately 20dB.This low noise amplifier is
Reference: PIGTAIL-F-MALE-N-F-739
Pigtail cable adapter F Male to N Female with coaxial cable RG316, 50 ohms, 15cm. The F connector is particularly used for satellite equipment.
Reference: CABLE-COAXIAL-SMA-M-1M-302
Cable SMA Male to SMA Male with 50-ohm coaxial cable low loss KSR195 for use from 0 to 6GHz.Length: 0,5m (50cm), 1, 3 or 5 metersConnector 1: SMA MaleConnector 2: SMA Male
Reference: EBYTE-E01-2G4M27D-1047
EBYTE PCB 2.4Ghz transceiver module, based on nRF24L01P RF chip, with 500mW power, TCXO, built-in LNA and SMA female antenna connector.Delivered with: 1 RF transceiver module 2.4Ghz PCB EBYTE
Reference: ADAPT-F-M-N-F-732
RF adapteur F Male to N female. Nickelplated. The F connector is particularly used for satellite equipment.
Reference: CABLE-COAX-F-M-SMA-1M-875
RF coaxial cable F Male to SMA Male, with RG58 coaxial cable, available in 1, 2, 5 or 10m. The F connector is particularly used for TV and satellite equipment.
Reference: QO100-BAGUE4-207245-23MM-1111
This ring makes it possible to reduce and offset a diameter of 40mm to a diameter of 23mm.thanks to its off-center center, this ring allows the antenna to be offset in order to better illuminate the
Reference: PIGTAIL-F-MALE-UHF-F-738
Pigtail cable adapter F Male to UHF Female with coaxial cable RG316, 50 ohms, 15cm. The F connector is particularly used for satellite equipment.
Reference: OCTAGON-BOITIER-PILE-792
Octagon battery pack to power a LNB satellite head in portable, with 75 ohms cable and 15cm length.The case requires 10 LR6 or AA rechargeable batteries (not included).Comes with: 1 battery pack
Reference: QO100-LENTILLE-POTY-927
New version of the lens for the POTY antenna and 10 Ghz receiving of the QO-100 satellite with f/D 0.6 offset dish.Amateur radio design: PE1CKKMaterial: PA6 extruded nylonDelivered with: 1 dielectric
Reference: ADAPT-F-M-SMA-F-730
RF adapteur F Male to SMA female. Nickelplated. The F connector is particularly used for satellite equipment.
Reference: PIGTAIL-F-M-SMA-M-736
Pigtail RF adapter F Male to SMA Male, with RG316 coaxial cable, available in 3 lenght: 15cm, 50cm or 1 meter. The F connector is particularly used for TV and satellite equipment.
Reference: PIGTAIL-F-15CM-737
Pigtail RF adapter F Male to F Male with coaxial cable RG316, 50 Ohms, available in 15cm or 50cm lengh. The F connector is particularly used for satellite equipment.
Reference: ADAPT-F-M-SMA-M-731
RF adapteur F Male to SMA Male. Nickelplated. The F connector is particularly used for satellite equipment.
Reference: ADAPT-F-F-SMA-F-728
This RF adapter converts a F Female connector to a SMA Female connector. Suits for WIFI devices and application. The F connector is particularly used for satellite equipment.
Reference: ADAPT-F-F-SMA-M-729
This RF adapter converts a F Female connector to a SMA Male connector. Suits for WIFI devices and application. The F connector is particularly used for satellite equipment.
Reference: QO100-BAGUE3-207217-22MM-1029
This ring allows a diameter of 40mm to be reduced to a diameter of 22mm. It is particularly suitable for mounting the POTY antenna on an LNB head support. Outside diameter: 40 mmInner diameter: 22
Reference: ADAPT-F-M-BNC-F-733
RF adapteur F Male to BNC female. Nickelplated. The F connector is particularly used for satellite equipment.
Reference: QO100-BAGUE1-206950-23MM-973
This ring allows a diameter of 40mm to be reduced to a diameter of 23mm. It is particularly suitable for mounting the DJ7GP antenna on an LNB head support.Outside diameter: 40 mmInner diameter: 23
Reference: QO100-CAP365-OCTAGON-761
Protection cap for LNB satellite reception head, protects the LNB from rain and snow. Extended life and extreme cold and heat resistance. Attaches directly to the LNB without metal fixation, suitable
Reference: ADAPT-F2-FEMELLE-734
This RF adapter converts a F Female connector to a F Female connector. Suits for WIFI devices and application. The F connector is particularly used for satellite equipment.
Reference: ADAPT-F2-MALE-735
RF adapteur F Male to SMA Male. Nickelplated. The F connector is particularly used for satellite equipment.
Reference: QO100-ADAPT-F-M-COUDE-748
RF adapter angled 90° F Male - F Female. The F connector is particularly used for satellite equipment.
Reference: OCTAGON-CABLE1-F-M-791
Octagon cable F male to F male with 75 ohm coaxial cable 20cm length.The F connector is used for television and satellite equipment.Delivered with: 1 Octagon F Male - F Male cable.
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal