No products
New products
-
Diamond HV5S mobile multiband antenna 40m/15m/6m/2m/70cm
108,59 € tax excl. -
Diamond SRH-36 VHF-UHF SMA-M 36cm antenna for Yaesu ICOM Kenwood TYT
29,90 € tax excl. -
AnyTone AT-D168UV Dual-band VHF-UHF walkie talkie in DMR/FM with GPS
159,00 € tax excl. -
Anytone QB-56HL 2600mAh battery for AT-168UV
19,90 € tax excl.
-
QO-100 navy blue organic cotton t-shirt size M to 5XL
9,00 € -40% 15,00 €
Software Defined Radio
Subcategories
SDR receivers
La gamme de récepteur et scanner SDR, HF, VHF, UHF et clé USB TNT SDR
SDR transceivers
SDR Antennas
Selecting suitable antennas for SDR, broadband VHF, UHF with SMA or BNC connector
SDR accessory
Reference: KRAKENSDR-FULL-PACK-2996
KrakenSDR SDR receiver pack + 5x antennas for direction finding
KrakenSDR is the enhanced version of KerberosSDR, an open-source multi-channel SDR receiver designed for direction finding, interferometry, triangulation and location analysis of RF signals from 100
959,00 €Online only
699,00 €Reference: KRAKENSDR-RECEPTEUR-3012
KrakenSDR 5-channel receiver for direction finding and radio triangulation
The KrakenSDR is a five-channel synchronised SDR receiver designed for radio direction finding and triangulation, analysis and steering of radio frequency signals. Based on the RTL2832U chip and the
699,00 €Online onlyReference: SDRPLAY-NRSP-ST-2864
nRSP-ST All-in-one SDR receiver 1kHz to 2GHz 14-bit Full IQ Integrated Web server
A new all-in-one receiver from SDRPlay, the nRSP-ST is a 14-bit SDR receiver with general coverage from 1 kHz to 2 GHz (without holes), integrating a receiver and a Web server with Ethernet or Wifi
569,00 €
349,00 €Reference: ANALOG-ADALM-PLUTO-788
PlutoSDR RX & TX 325 MHz - 3.8 GHz Full-Duplex - SDR QO-100 REV C
The PlutoSDR (Adalm-Pluto) REV C is an open-source SDR receiver and transmitter covering frequencies from 325MHz to 3.8GHz in half and full-duplex with a bandwidth of 20Mhz in 12bits.Adalm-Pluto was
349,00 €
319,00 €Reference: GSG-HACKRF-BOITE-75
HackRF One SDR Transceiver TX RX 1-6000MHz - RF development board - Genuine Version
The HackRF One is a SDR receiver-transmitter covering from 1MHz to 6GHz in all available modes, analog and digital.Tip: For use in the lab, or with strong signals nearby, the sensitivity of the device
319,00 €
299,00 €Reference: SDRPLAY-RSP-DUO-594
SDRPlay RSPduo 1KHz to 2GHz Double Tuner 14 Bit
The new SDRPlay RSPduo is a 14-bit SDR dual receiver that covers from 1kHz to 2GHz (without hole), with dual-tuner (simultaneous reception on 2 different antennas). The SDRDuo is equipped with a
299,00 €
295,00 €Reference: MALACHITE-SDR-V5-82T737-2731
Malachite SDR V5 10kHz-250MHz and 400MHz-2GHz receiver with DSP
The Malachite DSP SDR V5 receiver is a robust radio receiver with an aluminium casing offering a wide frequency coverage range from 10 kHz to 250 MHz and from 400 MHz to 2 GHz. This model incorporates
295,00 €Reference: SDRPLAY-RSPDX-935
SDRPlay RSPdx R2 1KHz - 2GHz 14-bit LNA metal case & 3 antenna ports
The new SDRPlay RSPdx R2 receiver covers from 1kHz to 2GHz (without hole) with 10MHz of the spectrum on the screen, 14-bit sampling, with TCXO 0.5PPM, notch filter MW / FM / DAB, rejector 88-108Mhz FM
265,00 €
194,12 €Reference: PACK-SDR-PORTABLE-V5-2544
Pack Passion SDR portable radio V5 with HF VHF UHF antenna
The Passion Radio SDR Portable V5 pack provides reception coverage between 0.1 and 1750 MHz (without holes) from a Windows, Mac or Linux computer, for fixed or mobile use with a laptop. This V5
194,12 €Online onlyReference: GSG-OPERA-CAKE-1757
Opera Cake 8 port automatic antenna switch for HackRF One
Opera Cake is an additional antenna switch card for the HackRF One SDR development board.This antenna switch can be configured with command line software for automatic port switching based on
189,00 €209,00 €
154,87 €Reference: SDRPLAY-RSP1B-2669
RSP1B SDR receiver 1kHz to 2GHz 14-bit + LNA + Bias-T + Metal case
A new version of SDRPlay's receiver, the RSP1B covers all frequencies from 1 kHz to 2 GHz without gaps, in all modes*, with up to 10 MHz of screen bandwidth and 14-bit sampling. The differences with
154,87 €
129,00 €Reference: PACK-SDR-DELUXE-281
Deluxe SDR Passion Pack V3
The new Deluxe Passion Radio SDR V3 pack include: - 1 USB TNT SDR stick new release (RTL2832U + tuner R820T2) - 1 converter HF SDR Ham it Up 1.3 (new release) - 1 USB cable male A-B 2.0 of 1.5 meters
129,00 €
124,86 €Reference: NOO-100846-HAM-IT-DOWN-2542
Downconverter 1.55 GHz to 3.1 GHz Nooelec Ham It Down with TCXO Bias-Tee
The Ham It Down is a downconverter capable of converting radio signals from 1.55 GHz to 3.1 GHz in the 50 MHz - 1.6 GHz frequency range and supported by SDR keys such as NESDR and RTL-SDR V3. It
124,86 €Online only
99,00 €Reference: NOOELEC-100769-HAM-IT-UP2-2420
Ham It Up Plus V2 Nooelec UpConverter SDR HF 0.3 to 65MHz with TCXO & box
RF converter (ULF/VLF/LF/MF/HF) for HF frequencies from 0.3 to 65 MHz and SDR (Software Defined Radio) devices such as NESDR keys, RTL-SDR, HackRF, or any VHF or SDR receiver covering the 125MHz to
99,00 €Online only
85,61 €Reference: NOO-100826-VEGA-2541
Nooelec VeGA variable gain amplifier LNA module Barebones 30MHz-4000MHz
The VeGA Barebones is a 30MHz to 4000MHz broadband linear LNA module designed to allow the user to control the level of amplification to achieve the best signal-to-noise ratio (SNR). The device can be
85,61 €Online only
75,87 €Reference: NOO-100825-HAM-IT-UP-NANO-2540
Ham It Up Nano 100kHz-65MHz HF Upconverter with TCXO Bias-Tee power supply unit
The Ham It Up Nano is an HF upconverter that lets you extend the range of your favourite SDR or radio to at least 100kHz. It is compatible with any radio capable of operating on 125MHz-190MHz (to use
75,87 €Online only
75,00 €Reference: NOO-100721-HAM-IT-UP-PLUS-441
Ham it Up 1.3 & 1.3+ Converter HF 0.5-50Mhz Nooelec
Nooelec's Ham It Up v1.3 is an up-converter HF, equipped with the 125Mhz filter soldered on the PCB and allows to listen to all MF / HF bands from 0.5 to 50 Mhz, in all modes of modulation, from a
75,00 €Online only
54,47 €Reference: NOOELEC-100701-NESDR2-421
Nooelec NESDR Smart V5 R820T2 SDR key + TCXO + Box + SMA antenna (optional)
The key NESDR SMART v5 is the new and improved version of the famous USB RTL-SDR dongle with the RTL2832U chipset and the R820T2/R860tuner, to receive all frequencies without gaps from 100kHz to
54,47 €
45,91 €Reference: CLE-RTLSDR-V3-472
Dongle RTL-SDR.com V3 TCXO + SMA + Bias-T USB stick with R860 tuner
This USB stick is the optimized V3 version of RTL-SDR.com, with the R860 tuner chip (exactly the same as R820T2*) for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:-
45,91 €Online only
43,46 €Reference: CLE-RTLSDR-V4-2402
RTL-SDR.com V4 TCXO USB key + SMA + Bias-T + R828D tuner 500kHz - 1766MHz
The RTL-SDR.com V4 USB SDR key incorporates the R828D tuner (instead of the R860 in V3) for reception from 500kHz to 1766 MHz.TCXO at 1 PPM Female SMA antenna connector Realtek RTL2832U chipset +
43,46 €Online only
29,90 €Reference: DONGLE-TNT2-COMPLET-249
USB key for HD DVB-T receiver for computer and smartphone
This USB TNT HD key enables you to receive free and TNT HD-compatible television channels from a PC, laptop, a raspberry Pi or smartphone with an OTG cable. The USB stick can also be used as a
29,90 €
25,90 €Reference: DONGLE-R820T2-TNT2-SEUL-248
RTL2832 USB key with R860 tuner (new version of the R820T2)
This model of RTL-SDR key is equipped with the Realtek RTL2832U chipset and the new R860 tuner, which is identical to the R820T2 tuner and has been specially designed for SDR mode. The antenna
25,90 €
19,96 €Reference: RFKONNECT-SONDE-81T625-2231
EMC EMI RF 9 KHz to 3 GHz probe kit SMA connector
PROBE EMC EMI Near Field Conduction Simple Magnetic Field Probe Kit with SMA ConnectorSpecification:- Working frequency: 9K - 3G- Weight: 21g- Connector: SMA female (SMA-K)Included in the package:- 5
19,96 €
18,86 €Reference: NOOELEC-100652-BALUN-HF-298
HF Antenna Balun 1:9 for SDR
This balun is the perfect accessory to connect a long wire antenna, for example with the converter HF SDR Ham it Up to listen shortwave and HF bands from 0.5 to 30Mhz, but this balun can work up to
18,86 €Online only
17,50 €Reference: QO100-OPA-BIAS-T1-760
BIAS-TEE for QO-100 or LNA 30MHz to 4GHz F1OPA
This BT4G-based BIAS-TEE with SMA female connector is used to power a LNA or a 10Ghz PLL LNB to receive the QO-100 / Es'Hail2 satellite.The BT4G covers the frequency bands from 30 MHz to 4 GHz. The
17,50 €Online only
Reference: RFKONNECT-PROTECT-64T197-2239
SDR Guard Protector to protect the SDR receiver antenna
SDR Receiver Guard Protector For Sensitive Receiver From High Level RF Effects - Specially designed to protect the front ends of sensitive receivers from high levels of RF effects from signals
8,50 €Reference: RFKONNECT-QO100-BIAS-T2-1267
BIAS-Tee RF power supply module for QO100 and LNA LNB heads
This BIAS-TEE module can be used to power an RF accessory such as an LNA preamp preamplifier or a LNB PLL 10Ghz to receive QO100. Power is supplied via an external DC power supply (30V max.) by
8,50 €
2,88 €Reference: RFKONNECT-FERR13MM-81T606-2216
13 mm ferrite for balun choke and interference suppression
13mm Black Ferrite Choke Balun for EMC Demagnetization Filter Anti-interference Device Clip-on VersionDescription:- It can filter high frequency noise, pulse interference from connection circuits.-
2,88 €
1,92 €Reference: RFKONNECT-FERR7MM-81T607-2217
7 mm ferrite for balun and interference suppression
7mm Black Ferrite Choke Balun for EMC Demagnetization Filter Anti-interference Device Clip-on VersionDescription:- It can filter high frequency noise, pulse interference from connection circuits.-
1,92 €
Delivery Europe & Overseas
Stock and shipped from France
Product return
14 days to return, 2 warranty
Email support
Response within 24h to 72h
Secure payment
SSL, VISA, Mastercard, Paypal
Copyright 2014-2025 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.