The Spiderbeam Heavy Duty 18m fibreglass mast...
The Spiderbeam Heavy Duty 18m fibreglass mast is a good choice for using a wide variety of 40/80/160m long-wire and GP or inverted L antennas, lightweight 1-element Quad or Delta loops for 20-10m, as well as dipoles for all HF and VHF-UHF bands, this mast can support small VHF/UHF yagi antennas to a height of 9-10m.
This 18m telescopic mast can be erected in a few minutes by a single person and has been specially designed for the robustness and durability requirements of portable equipment. It measures 118cm when fully folded.
It has a much thicker wall, 2mm at its thickest, than the usual "fishing rod".
It can be used with AWG 18 (= 1mm diameter) enamelled copper wire or similar to build vertical antennas, loops, dipoles, etc.
For guy wires, fine fishing monofilament (1mm diameter) or similar rope is ideal.
Supplied with: 1 Spiderbeam 18m mast and 11 rubber guy ropes.
* Due to production variations, the dimensions shown may vary slightly. This does not affect quality or performance.
Unlike the poles offered by most competitors, the top segment of the Spiderbeam mast is not a very thin, fragile whip. Instead, this mast can be used to its full 18m length, offering great flexibility and optimum use of height.
It uses a special reinforcement winding technique, where several layers of glass fibre are wound in an alternating direction (cross-winding), which considerably increases their lateral and linear strength.
The joints between the different tube segments are also strengthened thanks to a larger-than-usual overlap.
Unlike other poles where the top segment is very thin like a whip, the top segment of Spiderbeam Heavy Duty poles has a diameter of 40mm (and a wall thickness of 2mm), allowing them to be used over their full 18m length.
Invented by G5RV amateur, R. Louis VARNEY published for the first time the technical documentation of its antenna in November 1966. The G5RV wire antenna have 2 versions: 1/2 half size, about 16
40,83 €tax excl.
Diamond BU50/A balun 1:1, genuine, operates from 1.7 to 40Mhz and allows to receive and transmit on HF bands.Technical data sheet of the HF BU50A balun:● Operating frequency from 1.7 to 40MHz●
29,16 €tax excl.30,69 € -5%
Messi & Paoloni coaxial cable ready to use with UHF male connector (PL male), with a diameter of 7mm with M&P ULTRAFLEX 7 cable, very flexible and offering excellent performance with lower
34,08 €tax excl.
The EMCOMM III Portable antenna from Chameleon is a portable antenna from 1.8 to 30 MHz, specially designed for short to long range HF communications (DX). It is suitable for amateur radio bands and
186,04 €tax excl.195,83 € -5%
Diamond DAP-600 telescopic pole in 5 sections with diameters from 42 to 26mm, for a minimum height of 1.5m to a maximum of 6m, full extension. High strength anodised aluminium construction, complete
173,38 €tax excl.182,50 € -5%
The CHA Pocket OFCD is a 40m - 6m (7 to 54 MHz) multi-band HF antenna, WINDOM type, asymmetric dipole OCF (off-center-fed) and can fit in a pocket when not in use. This antenna is designed for
The Spiderbeam 10m Telescopic Pole is the ideal solution for users looking for a lightweight, easy to carry pole that can be set up quickly and easily. Compact and easy to store in any large suitcase
70,83 €tax excl.
The Spiderbeam Heavy Duty 12m fibreglass mast is the right choice for using a wide variety of 40/80/160m long wire and GP or inverted L antennas, lightweight 1-element Quad or Delta loops for 20-10m,
104,17 €tax excl.
The M0CVO HW-40HP is a dipole antenna that incorporates the M0CVO 4:1 balun at the feed point, allowing direct feeding with 50 ohm coaxial cable. The M0CVO HW-40HP is just 20.28m long, and can be
59,38 €tax excl.62,50 € -5%
The M0CVO high power 1:1 Balun operates from 1.8 to 30MHz. It can handle up to 400W CW or 450W PEP in SSB. It is used to match a balanced antenna, such as a dipole, to an unbalanced feed such as
36,34 €tax excl.38,25 € -5%
The M0CVO high power 4:1 Balun operates from 1.8 to 54MHz. It supports up to 400W CW or 500W PEP in SSB. It is used to convert the 200Ω impedance seen at the feed point of a bent or off-centre fed
36,34 €tax excl.38,25 € -5%
MASTRANT-P3 is a 2.6mm rope with a strength of 200 daN/kg, specially designed for guy ropes, offering an excellent price-performance ratio. This high quality rope has outstanding strength, low
20,42 €tax excl.21,49 € -5%
MASTRANT-P3+ is a 1.6mm rope with a strength of 300 daN/kg. This high quality rope has outstanding strength, low stretch, excellent UV and moisture resistance. It is lightweight, extremely abrasion
27,48 €tax excl.28,93 € -5%
MASTRANT-P4 is a 4.4mm rope with a strength of 440 daN/kg and is available in neon blue and black. This high quality rope has outstanding strength, low stretch, excellent UV and moisture resistance.
32,97 €tax excl.34,71 € -5%
Ultra-strong guy straps for Spiderbeam 18m telescopic masts, with attachment points for 3 or 4 guy wires, allowing 90° or 120° orientation and attachment of the guy wires to ground stakes
22,61 €tax excl.
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal