Nuand case for bladeRF 2.0 micro xA4 and xA9

Additional or similar equipment

• 

  Pigtail SMA Male - SMA Male 15/30/50/100cm RG316

  Pigtail RF adapter SMA Male to SMA Male to connect for example a converter Ham it up to a HackRF One, or SDRPlay, and any device with a SMA female connector. Coaxial cable RG 316 50 ohms. Available in

  5,00 € tax incl.

  4,17 €tax excl.

  In stock
• 

  Coaxial cable extension low loss 2X SMA Male

  Cable SMA Male to SMA Male with 50-ohm coaxial cable low loss KSR195 for use from 0 to 6GHz.Length: 0,5m (50cm), 1, 3 or 5 metersConnector 1: SMA MaleConnector 2: SMA Male

  8,90 € tax incl.

  7,42 €tax excl.

  In stock, send from Europe
• 

  MMIC prototyping circuit PCB board for SMA

  MMIC prototype circuit on PCB for connection with SMA connectors (available as an option below).Supplied without SMA connector (solder).Fits standard SMA PCB connectors, including with SMA

  2,00 € tax incl.

  1,67 €tax excl.

  In stock
• 

  BT-100 Nuand TX Power Amplifier for BladeRF 2.0 micro

  The BT-100 is a TX power amplifier, powered by Bias-T, to connect to the SMA TX socket of the bladeRF 2.0 micro xA4 and xA9.MMIC: PHA-1H +TX frequency: 50 MHz to 6 GHzConsumption: 200mWBlue LED power

  45,00 € tax incl.

  37,50 €tax excl.

  Material no longer available
• 

  BT-200 Nuand RX LNA for BladeRF 2.0 micro

  The BT-200 is a RX LNA, powered by Bias-T, to connect to the SMA RX socket of the bladeRF 2.0 micro xA4 and xA9.MMIC: TSS-53LNB+TX frequency: 500 MHz to 5 GHzConsumption: 300mWGreen LED power

  25,00 € tax incl.

  20,83 €tax excl.

  Material no longer available