RF Splitter 0 to 5000Mhz Attenuation 6dB with SMA

This RF module allows you to separate a signal on 2 SMA outputs, with an attenuation of -6dB between the 2 outputs, for use from 0 to 5000Mhz (5Ghz).

Supplied with: 1 2-channel RF RF Splitter module.

More details

Data sheet

RF splitter specifications

Frequency: 0 Mhz to 5000 Mhz
Connector: SMA female
Dimensions: 33 x 33 x 3 mm

2 years warranty*

* The warranty does not cover damage that may result from a mounting error, an incorrect antenna setting (ROS), a maximum input power not respected, a short circuit of the power supply or coaxial line and damage from electrostatic discharge.

Accessories

SMA Male UHF Female Adapter (SO-239)
SMA Male UHF Female (SO-239) Adapter.
4,00 € 5,00 € -20%
In stock
Pigtail SMA Male - SMA Male 15/30/50/100cm RG316
Pigtail RF adapter SMA Male to SMA Male to connect for example a converter Ham it up to a HackRF One, or SDRPlay, and any device with a SMA female connector. Coaxial cable RG 316 50 ohms. Available in
4,00 € 5,00 € -20%
In stock
LNA VHF UHF preamplifier with PGA-103 + for RF and SDR application
The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on
Adapter SMA male SMA male
This RF adapter allows is equipped with an SMA Male connector on both sides.It allows to connect for example 2 cables or connectors in SMA female.
3,60 € 4,50 € -20%
In stock
Adapter SMA Female SMA Female
This RF adapter allows is equipped with an SMA Female connector on both sides.It allows to connect for example 2 cables or connectors in SMA Male.
3,20 € 4,00 € -20%
In stock
RF attenuator SMA 0-6 Ghz from -3 to -30dB 2W
This adapter is a SMA attenuator available in version -3, -6, -10, -15, -20 or -30dB for frequencies from 0 to 6 Ghz.Connector end 1 : SMA maleConnector end 2 : SMA femaleImpedance : 50 OhmsMaximum
7,92 € 9,90 € -20%
In stock
LNA preamp 50-4000 Mhz with SPF5189Z
This SPF5189Z LNA preamp improves reception performance from 50 Mhz to 4000 Mhz, based on SPF5189Z, with a noise factor of 0.6 dB and a maximum gain of approximately 20dB.This low noise amplifier is