Case for transverter XB 200

Accessories

• 

  Pigtail SMA Male to UHF Female

  SMA Male to UHF Female Adapter. RG 316 coaxial cable 50 ohms, about 15cm long.

  6,90 €

  In stock
• 

  Pigtail SMA Male - SMA Male 15/50/100cm

  Pigtail RF adapter SMA Male to SMA Male to connect for example a converter Ham it up to a HackRF One, or SDRPlay, and any device with a SMA female connector. Coaxial cable RG 316 50 ohms. Available

  5,00 €

  In stock
• 

  Pigtail SMA Male to BNC Female

  SMA Male to BNC Female Adapter. RG 316 coaxial cable 50 ohms, about 15cm long.

  7,90 €

  In stock
• 

  Adaptateur SMA Male BNC Femelle

  Adaptateur SMA Male vers BNC Femelle. Compatible avec la carte converter HF Ham It Up, HackRF et le récepteur SDR FUNcube Dongle Pro+.

  5,90 €

  In stock
• 

  Magnet SMA base bracket

  Diamond MCRMSMA is a magnet base bracket for handheld transceivers and any devices with SMA connector. Coaxial cable: RG58 2.5m Connector: SMA Male / SMA FemaleMagnet diameter: 53mm

  49,90 €

  Out of stock
• 

  Adapter SMA male SMA male

  This RF adapter allows is equipped with an SMA Male connector on both sides.It allows to connect for example 2 cables or connectors in SMA female.

  4,50 €

  In stock
• 

  USB VFO jog Shuttle Xpress Contour Design for SDR

  Allows to control by USB the change of frequencies of an SDR software and to get a classic operation of a VFO on a radio hardware SDR!Fully configurable with the supplied software, Shuttle Xpress is

  53,00 €

  Out of stock, available 5-7 days
• 

  HF Antenna Balun 1:9 for SDR

  This balun is the perfect accessory to connect a long wire antenna, for example with the converter HF SDR Ham it Up to listen shortwave and HF bands from 0.5 to 30Mhz, but this balun can work up to

  12,50 €

  In stock
• 

  Coaxial cable low loss 2X SMA Male

  Cable SMA Male to SMA Male with 50-ohm coaxial cable low loss KSR195 for use from 0 to 6GHz.Length: 0,5m (50cm), 1, 3 or 5 metersConnector 1: SMA MaleConnector 2: SMA Male

  8,90 €

  In stock, send from Europe
• 

  BLADERF x115 RX & TX 300-3800 Mhz

  The x115 bladeRF from Nuand is a SDR transceiver full-duplex from 300 MHz to 3.8 GHz, all analog and digital modes, with appropriate software. 2 connectors antenna SMA female, Altera Cyclone IV FPGA.

  950,00 €

  Available on backorder within 10-15 days
• Sale!

  Transverter 60kHz to 300MHz Nuand XB 200

  Transverter 60kHz to 300MHz, LF/MF/HF/VHF, Nuand XB 200 for SDR BladeRF X40 and X115.Filtered frequency range down to 60kHz RX and TX filters for 50MHz-54MHz (6 meter band), 149MHz-159MHz

  262,50 € 375,00 € -30%

  In stock
• 

  Case for bladeRF x40 & x115

  Genuine case for Nuand BladeRF X40 or x115.

  35,90 €

  Available on backorder within 10-15 days
• 

  BLADERF x40 RX & TX 300-3800 Mhz

  The bladeRF x40 from Nuand is a SDR transceiver full-duplex from 300 MHz to 3.8 GHz, all analog and digital modes, with appropriate software. 2 connectors antenna SMA female, Altera Cyclone IV FPGA.

  689,00 €

  Available on backorder within 7-10 days
• 

  Enclosure kit for Ettus USRP B200 MINI

  Ettus official protective metal case for the USRP B200 MINI SDR transceiver. This enclosure kit allows users to assemble a steel case to protect the B200MINI board-only device, and increases operating

  59,00 €

  In stock