Nooelec aluminium case V2 (new version)...
Nooelec aluminium case V2 (new version) specifically designed for HackRF One reduce parasitic interference nearby and add a stronger resistant case.
This aluminum case is for replacing the original plastic box.
Comes with: 1 Nooelec genuine case V2 new version, with 2 covers, 2 front panels and 1 bag of screws. The LED light guide is not included with this case, to recover if necessary on the original plastic case.
Nooelec's Ham It Up v1.3 is an up-converter HF, equipped with the 125Mhz filter soldered on the PCB and allows to listen to all MF / HF bands from 0.5 to 50 Mhz, in all modes of modulation, from a
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on
Preamplifier and LNA (low noise amplifier) specially adapted with BIAS-T for HackRF One, AirSpy, SDRPlay and RTL-SDR V3 usb stick. It highly increases the reception performance (+ 11dB to + 23dB) and
Allows to control by USB the change of frequencies of an SDR software and to get a classic operation of a VFO on a radio hardware SDR!Fully configurable with the supplied software, Shuttle Xpress is
This RF shield Nooelec and component kit is specifically designed for HackRF One to eliminates EMI nearby. Comes with: RF shield, shield frame, shield cover, GND clip testpoint, J10, and a 20
Telescopic Antenna ANT700 from 300 to 1100 MHz, made by Great Scott Gadgets. The total length of the antenna ANT700 is configurable from 9.5 cm to 24.5 cm. The ANT700 is constructed of stainless
Great Scott Gadgets official case, transparent acrylic for the bare HackRF card One or to replace the black plastic case of HackRF. Case to assemble (instructions below). Delivered without HackRF.
The PortaPack, developp by ShareBrained, is the perfect complement for the HackRF One, it adds a touch screen, navigation buttons, a headphone jack, a real-time clock and a micro SD card reader.Paired
This ultra-flat 10 MHz Tiny TCXO module is for HackRF One. This 0.5 ppm TCXO improves performance with ultra-low phase noise and high frequency stability in almost any condition.Perfect for any high
Be the first to ask a question about this product!
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal