Telescopic antenna ANT500, VHF-UHF 50 ohms...
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °.
This is an antenna for use with a broadband or HackRF One, SDRPlay. Works for SDR reception, VHF, UHF or ADSB.
The HackRF One is a SDR receiver-transmitter covering from 1MHz to 6GHz in all available modes, analog and digital.Tip: For use in the lab, or with strong signals nearby, the sensitivity of the device
231,75 €tax excl.309,00 € -10%
Diamond MCRMSMA is a magnet base bracket for handheld transceivers and any devices with SMA connector. Coaxial cable: RG58 2.5m Connector: SMA Male / SMA FemaleMagnet diameter: 53mm
37,43 €tax excl.49,90 € -10%
Dual band directional antenna Original Diamond SRH779, 44cm long, with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands
22,20 €tax excl.29,60 € -10%
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
24,68 €tax excl.32,90 € -10%
This RF adapter allows is equipped with an SMA Male connector on both sides.It allows to connect for example 2 cables or connectors in SMA female.
3,38 €tax excl.4,50 € -10%
Allows to control by USB the change of frequencies of an SDR software and to get a classic operation of a VFO on a radio hardware SDR!Fully configurable with the supplied software, Shuttle Xpress is
44,17 €tax excl.
This RF shield Nooelec and component kit is specifically designed for HackRF One to eliminates EMI nearby. Comes with: RF shield, shield frame, shield cover, GND clip testpoint, J10, and a 20
7,43 €tax excl.9,90 € -10%
Nooelec aluminium case V2 (new version) specifically designed for HackRF One reduce parasitic interference nearby and add a stronger resistant case. This aluminum case is for replacing the original
28,43 €tax excl.37,90 € -10%
Telescopic Antenna ANT700 from 300 to 1100 MHz, made by Great Scott Gadgets. The total length of the antenna ANT700 is configurable from 9.5 cm to 24.5 cm. The ANT700 is constructed of stainless
21,68 €tax excl.28,90 € -10%
Antenna Nagoya NA-810 7.5cm long, dual-band 144Mhz & 430MHz with a gain of 0dBi, SMA male connector, and 150/300/450/800/900 MHz receive onlyFrequency RX & TX: 144Mhz and 430MHzReceive only
7,29 €tax excl.9,72 € -10%
This antenna Nagoya NA-707 is tilting and telescopic (61cm unfolded, 15,8cm folded), for effective reception from 80Mhz to 1000Mhz (announced RX from 1.8Mhz to 1800Mhz by the manufacturer), and can be
8,91 €tax excl.11,88 € -10%
Great Scott Gadgets official case, transparent acrylic for the bare HackRF card One or to replace the black plastic case of HackRF. Case to assemble (instructions below). Delivered without HackRF.
6,75 €tax excl.9,00 € -10%
This ultra-flat 10 MHz Tiny TCXO module is for HackRF One. This 0.5 ppm TCXO improves performance with ultra-low phase noise and high frequency stability in almost any condition.Perfect for any high
22,43 €tax excl.29,90 € -10%
Opera Cake is an additional antenna switch card for the HackRF One SDR development board.This antenna switch can be configured with command line software for automatic port switching based on
156,75 €tax excl.209,00 € -10%
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal