Nooelec Module Tiny TCXO 10Mhz for HackRF

This ultra-flat 10 MHz Tiny TCXO module is for HackRF One. This 0.5 ppm TCXO improves performance with ultra-low phase noise and high frequency stability in almost any condition.

Perfect for any high precision experimentation with the HackRF One, such as projects with GPS.

The module is very simple to install, simply connect it to the HackRF circuit board.

Please note: This module can not be installed in the plastic case of HackRF One, only with the nooelec metal case for HackRF.

Delivered with: 1 module Nooelec Tiny TCXO 10 Mhz for HackRF One.

Accessories

ANT500 SDR ADSB antenna 75-1000Mhz SMA-M
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
32,90 €
In stock
Magnet SMA base bracket
Diamond MCRMSMA is a magnet base bracket for handheld transceivers and any devices with SMA connector. Coaxial cable: RG58 2.5m Connector: SMA Male / SMA FemaleMagnet diameter: 53mm
49,90 €
Out of stock
Diamond antenna SRH-789 SMA-M 95-1100Mz + TX 144/430Mhz
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
29,90 €
In stock
LNA preamplifier for HF SDR 500 kHz to 30 MHz from F1OPA
The LNA HF from F1OPA is a pre-amplifier and a low-pass filter (LNA), very powerful (+18dB to +20dB), with SMA Female connectors, for HF frequencies and short waves from 500 kHz to 30 MHz, with
34,50 €
In stock
LNA VHF UHF preamplifier with PGA-103 + for RF and SDR application
The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on
LNA preamp with BIAS-T for HackRF Airspy SDRPlay
Preamplifier and LNA (low noise amplifier) specially adapted with BIAS-T for HackRF One, AirSpy, SDRPlay and RTL-SDR V3 usb stick. It highly increases the reception performance (+ 11dB to + 23dB) and
USB VFO jog Shuttle Xpress Contour Design for SDR
Allows to control by USB the change of frequencies of an SDR software and to get a classic operation of a VFO on a radio hardware SDR!Fully configurable with the supplied software, Shuttle Xpress is
53,00 €
In stock
Nooelec RF Shield Kit for HackRF One
This RF shield Nooelec and component kit is specifically designed for HackRF One to eliminates EMI nearby. Comes with: RF shield, shield frame, shield cover, GND clip testpoint, J10, and a 20
9,90 €
In stock
Aluminium case HackRF One - Nooelec
Nooelec aluminium case V2 (new version) specifically designed for HackRF One reduce parasitic interference nearby and add a stronger resistant case. This aluminum case is for replacing the original
34,90 €
In stock
Antenna ANT700 300-1100Mhz SDR VHF UHF ADSB
Telescopic Antenna ANT700 from 300 to 1100 MHz, made by Great Scott Gadgets. The total length of the antenna ANT700 is configurable from 9.5 cm to 24.5 cm. The ANT700 is constructed of stainless
28,90 €
In stock
Clear Acrylic Case for HackRF One by GSG
Great Scott Gadgets official case, transparent acrylic for the bare HackRF card One or to replace the black plastic case of HackRF. Case to assemble (instructions below). Delivered without HackRF.
9,00 €
In stock
PortaPack H1 Havoc for HackRF One by ShareBrained
The PortaPack, developp by ShareBrained, is the perfect complement for the HackRF One, it adds a touch screen, navigation buttons, a headphone jack, a real-time clock and a micro SD card reader.Paired
199,00 €
In stock
Source GPSDO clock reference 10 Mhz OCXO DX Patrol
DX Patrol's GPSDO (GPS Disciplined Oscillator) is made up of a GPS receiver (U-Blox 7N) and a 10 Mhz OCXO oscillator with pure sine wave and very high stability (0.05ppb*), disciplined thanks to the
129,00 €
Out of stock, available in 2-3 weeks