Viewed products
Printed circuit PCB wifi antenna WA5VJB Quad...
Printed circuit PCB wifi antenna WA5VJB Quad Patch for 2.4Ghz with a gain of 12dBi.
The antenna is delivered without connector (solder wire).
Frequencies: 2400-2480 MHz (WIFI 2.4 Ghz)
Type: Patch PCB
Number of elements: 4
Gain: 12dBi
Impedance: 50 ohms
Amateur radio design: WA5VJB
Dimensions: 154x96mm
Weight: 49 grams
Reference: GOODIES-CARTE-660
This Passion Radio anti-RFID card holder makes it possible to secure your bank card data thanks to its anti-RFID shield, this card holder made in France will block all unwanted contactless payments.
Reference: WA5-ANT-PATCH4-5800-783
Printed circuit antenna WA5VJB Quad Patch for 5.8Ghz with a gain of 12dBi. The antenna is delivered without connector (solder wire on the PCB).Frequencies: 5800 MHzType: PatchNumber of elements:
18,50 €
Reference: ANT-GSM-29CM-278
High-efficiency antenna with 5dbi gain, SMA male connector for GSM and multiband devices 3G, 4G, UMTS, WIFI, EDGE and GPRS. Frequencies : 690-960Mhz and 1710-2620MHzConnector: SMA maleLength: 29
Reference: CABLE-COAXIAL-SMA-M-1M-302
SMA Male to SMA Male cable with KSR195 low-loss 50 ohm coaxial cable for use from 0 to 6Ghz. Available lengths: 0.5m (50cm), 1, 3 or 5 metresConnector 1: SMA MaleConnector 2: SMA Male
Reference: CABLE-COAXIAL-SMA-M-1M-4959
Low-loss 50 ohm coaxial cable KSR195 5mm, for use from 0 to 6Ghz and with an SMA Male connector at one end and without connector at the other end (bare end to be soldered or crimped). Length:
Reference: QO100-ANT-POTY-SMA-762
The POTY (Patch Of The Year) antenna is a dual-band 2.4 GHz /10 GHz antenna, with left-hand circular polarization LHCP for 2400 MHz transmission and a linear horn antenna for 10500 MHz reception with
Click here to leave a review
Be the first to ask a question about this product!
High-efficiency antenna with 5dbi gain, SMA male connector for GSM and multiband devices 3G, 4G, UMTS, WIFI, EDGE and GPRS. Frequencies : 690-960Mhz and 1710-2620MHzConnector: SMA maleLength: 29
11,58 €tax excl.
SMA Male to SMA Male cable with KSR195 low-loss 50 ohm coaxial cable for use from 0 to 6Ghz. Available lengths: 0.5m (50cm), 1, 3 or 5 metresConnector 1: SMA MaleConnector 2: SMA Male
7,42 €tax excl.
Low-loss 50 ohm coaxial cable KSR195 5mm, for use from 0 to 6Ghz and with an SMA Male connector at one end and without connector at the other end (bare end to be soldered or crimped). Length:
7,42 €tax excl.
The POTY (Patch Of The Year) antenna is a dual-band 2.4 GHz /10 GHz antenna, with left-hand circular polarization LHCP for 2400 MHz transmission and a linear horn antenna for 10500 MHz reception with
57,50 €tax excl.
The Analog Devices CN0417 is a small RF power amplifier, powered by micro-USB, optimized to operate on 2400 MHz with 100mW max, gain of 20-21dB max., with a integrated bandpass filter 2400 to
57,50 €tax excl.
Printed circuit antenna WA5VJB Quad Patch for 5.8Ghz with a gain of 12dBi. The antenna is delivered without connector (solder wire on the PCB).Frequencies: 5800 MHzType: PatchNumber of elements:
7,71 €tax excl.
18,50 € -50%The PlutoSDR (Adalm-Pluto) REV C is an open-source SDR receiver and transmitter covering frequencies from 325MHz to 3.8GHz in half and full-duplex with a bandwidth of 20Mhz in 12bits.Adalm-Pluto was
290,83 €tax excl.
PCB WIFI 2400 Mhz (2.4 Ghz) antenna with 4dBi gain. The antenna is supplied with a 15cm long soldered wire and an IPEX UFL connector. Frequencies: 2400-2490 MHz Bands: WIFI 802.11n/b/gGain:
3,75 €tax excl.
11cm WIFI antenna with a gain of 2dbi for the 2.4 Ghz and 5 Ghz wifi bands, with RP-SMA male reverse connector for dual-band wifi device and router (2G and 5G).Comes with: 1 original Nagoya NW-2458 2G
3,75 €tax excl.
VHF/UHF/SHF digital and analog amateur radio base IC-905, all modes coverage: 144/430/1200MHz (10W), 2400/5600MHz (2W) and 10GHz (0.5W) with CX-10G (optional). All modes: SSB, CW, AM, FM, D-STAR
3 332,50 €tax excl.
13cm 2.4GHz amplifier for QO-100 compatible with the use of a Adalm Pluto to be operational on the QO-100 satellite in SDR with a maximum power of 10W on the 13cm 2.4 GHz band. With integrated TCXO,
332,50 €tax excl.
RigExpert's 2.4GPA power amplifier is designed to operate in the 2.0 to 2.6 GHz frequency band, including 2.4GHz frequencies. It can be used with an input power of 9-14.5 dBm (8-28mW) and a maximum
207,50 €tax excl.
259,00 €Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal
Copyright 2014-2025 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.