Delivery can be delayed locally due to COVID, for fast delivery use only UPS, Fedex or DHL.
Online only
Fixed vertical fiberglass antenna with mast mounting bracket included, for outdoor use on the ISM 868 Mhz band (LoRa and Sigfox), with a gain of 2db and female SMA connector.
This antenna consists of a half-wave dipole encapsulated inside a fiberglass radome with an aluminum mounting base.
A mast bracket is included to facilitate installation on a 35-70mm diameter mast.
Supplied with: 1 fixed antenna 868Mhz from OPA Design, with mast fixing bracket.
Frequency: ISM band 868 MHz
Antenna type: Dipole 1/2 wave
UV-resistant white fiberglass radome
Connector: SMA female
Installation type: Mast Diam 35-70 mm, mast mounting bracket included
Gain: 2dBi
SWR: ≤1.5
Type of Polarization: Vertical
Maximum power: 10W
Impedance: 50 Ohms
Dimensions: 25cm
Tube diameter: 30mm
Made in France
2 years warranty
The LNA HF from F1OPA is a pre-amplifier and a low-pass filter (LNA), very powerful (+18dB to +20dB), with SMA Female connectors, for HF frequencies and short waves from 500 kHz to 30 MHz, with
PCB antenna Yagi 3 elements for 868MHz with a gain of 8dBi, for long-range use on the ISM 868Mhz frequency band and LPWAN / LoRaWan networks (Sigfox, LoRa), RFID UHF and Zigbee. The antenna is
This filter for the 868 Mhz bandpass improves selectivity and suppresses spurious signals outside the 868Mhz band.Utilization type unlicensed ISM bande 868 Mhz: Sigfox, LoRa, LoRaWAN.Supplied with: 1
Antenna 868 MHz with a gain of 2dBi for short-distance use on the ISM 868Mhz frequency band for LoRa, LoRaWan, Sigfox or Zigbee IoT networks. The antenna is soldering on a PCB.Frequencies: 868-869
868 Mhz antenna with 2dbi gain, SMA male right angle connector for hardware device on 868Mhz ISM band and LoRa / LoRaWan application.Frequencies: 868 Mhz +/- 3MhzConnector: SMA male - right angleGain:
Antenna stubby for ISM LoRa 868 Mhz band, 4cm long with 2dbi gain, SMA male connector.Frequencies RX and TX: 868 MhzConnector: SMA maleGain: 2dBiSWR: ≤1.5Polarization Type: VerticalMaximum power:
This EBYTE E32 module is a 100mW long range transceiver with UART interface, available in 433Mhz or 868Mhz version and based on SEMTECH chip SX1276 (868Mhz) and SX1278 (433Mhz) for LoRa network and
This LoRa tracker TTGO T BEAM is an IoT development board for LoRa 433 Mhz or 868 Mhz frequencies (depending on the model), with WIFI 802.11 b / g / n connection, Bluetooth / BLE, 2.4cm OLED display
Magnetic antenna for the 868 Mhz frequency, LoRa and ISM transmission and reception, 29cm long with a gain of 3.5dbi, SMA male connector and RG174 coaxial cable of 1m.Supplied with: 1 Ebyte 868Mhz
The LoStik dongle is LoRa, LoRaWAN and The Things Network (TTN) compatible, easy to use directly from a PC or Raspberry PI.It enables IoT (Internet of Things) integrators, 868Mhz wireless network
The IoT LoRa Raspberry Pi HAT allows to create an economical LoRa gateway compatible with The Things Network (TTN) on the ISM Europe 868Mhz band.This HAT for Raspberry Pi allows you to configure your
Fixed vertical fiberglass antenna for ADS-B 1090 Mhz reception, for use as an outdoor pole, with mounting bracket included and female N antenna connector.This ADS-B antenna consists of a half-wave
Rotating antenna for the 868 Mhz frequency, LoRa and ISM transmission and reception, 20cm long with a gain of 3dbi, SMA male connector.Supplied with: 1 Ebyte 868Mhz antenna.
Cliquez ici pour donner votre avis
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal