The x115 bladeRF from Nuand is a SDR transceiver full-duplex from 300 MHz to 3.8 GHz, all analog and digital modes, with appropriate software. 2 connectors antenna SMA female, Altera Cyclone IV FPGA.
The BladeRF 115 can display up to 40 MHz of radio spectrum on the screen with a 12-bit sampling.
Run on Linux with the open-source software GNUradio.
Package includes: Board bladeRF x115 (115KLE Cyclone FPGA), USB 3.0 cable SS, 2 SMA cable.
Compatible antennas in option: Diamond SRH-789 and ANT500.
SMA Male UHF Female (SO-239) Adapter.
Telescopic antenna ANT500, VHF-UHF 50 ohms designed to operate in RX from 75 MHz to 1 GHz. Configurable length of 20 cm to 88 cm. Stainless steel SMA male connector and elbow swivel 360 °. This is an
SMA Male to N Female Adapter. Coaxial cable RG 316 50 ohms. Available in 15cm, 50cm or 1 meter length (to choose from below).
SMA Male to UHF Female Adapter. RG 316 coaxial cable 50 ohms, about 15cm long.
Pigtail RF adapter SMA Male to SMA Male to connect for example a converter Ham it up to a HackRF One, or SDRPlay, and any device with a SMA female connector. Coaxial cable RG 316 50 ohms. Available in
Diamond MCRMSMA is a magnet base bracket for handheld transceivers and any devices with SMA connector. Coaxial cable: RG58 2.5m Connector: SMA Male / SMA FemaleMagnet diameter: 53mm
Dual band directional antenna Original Diamond SRH-789 with SMA Male connector, for receiving and transmitting on VHF-UHF bands (144/430 MHz) and reception on aviation bands 120/150/300/450/800 MHz
This RF adapter allows is equipped with an SMA Male connector on both sides.It allows to connect for example 2 cables or connectors in SMA female.
Cable SMA Male to SMA Male with 50-ohm coaxial cable low loss KSR195 for use from 0 to 6GHz.Length: 0,5m (50cm), 1, 3 or 5 metersConnector 1: SMA MaleConnector 2: SMA Male
SDR Transceiver wide-band from 70 MHz to 6 GHz without gap and with 56 MHz of instantaneous bandwidth on the screen. The Ettus USRP B200 MINI operates in full duplex mode and is powered by USB 3.0
This directional Log Periodic antenna is designed in PCB and operates from 850MHz to 6,5GHz with 5-6 dBi gain. Works with Ettus USRP B200mini and all equipment operating in this frequency range. The
Transverter 60kHz to 300MHz, LF/MF/HF/VHF, Nuand XB 200 for SDR BladeRF X40 and X115.Filtered frequency range down to 60kHz RX and TX filters for 50MHz-54MHz (6 meter band), 149MHz-159MHz
Genuine case for Nuand BladeRF X40 or x115.
PCB Log periodic antenna, for frequency from 400 to 1000MHz with a gain of 6 dBi.Supplied without SMA connector (soldering) or via a coaxial cable soldered directly to the PCB.Frequencies: 400-1000
The bladeRF x40 from Nuand is a SDR transceiver full-duplex from 300 MHz to 3.8 GHz, all analog and digital modes, with appropriate software. 2 connectors antenna SMA female, Altera Cyclone IV FPGA.
The XTRX PRO is the first embedded SDR in Mini PCI format and with RX and TX in Full-Duplex (2x2 MIMO) for frequencies from 30Mhz to 3.8Ghz, stabilized with integrated GPSDO, sampling rate up to 120
Be the first to ask a question about this product!
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal