Delivery can be delayed locally due to COVID, for fast delivery use only UPS, Fedex or DHL.
Active Whip mini-antenna for receiving HF frequencies from 10khz to 30 mhz with an SDR receiver or a short and HF receiver. Antenna connector: SMA female.
This active antenna need to be powered with 12V or 9-15V.
Supplied with: 1 PCB mini whip antenna and 1 PCB Bias-Tee, without cable.
Reception frequency: 10khz to 30Mhz
Integrated LNA preamp
Power supply by Bias-T supplied: From 9 to 15V, nominal power supply 12V
Antenna connector: SMA female
For optimal performance, this active antenna must be installed outdoors (protected by a waterproof case), away from all metal sources and at a height of at least 2 meters.
Nooelec's Ham It Up v1.3 is an up-converter HF, equipped with the 125Mhz filter soldered on the PCB and allows to listen to all MF / HF bands from 0.5 to 50 Mhz, in all modes of modulation, from a
Pigtail RF adapter SMA Male to SMA Male to connect for example a converter Ham it up to a HackRF One, or SDRPlay, and any device with a SMA female connector. Coaxial cable RG 316 50 ohms. Available in
This Mini-Whip SDR active antenna allows reception of HF frequencies from 0 to 50 mhz with an SDR receiver.Compact in size, the mini-whip active antenna can be used independently with a 9-volt battery
Allows to control by USB the change of frequencies of an SDR software and to get a classic operation of a VFO on a radio hardware SDR!Fully configurable with the supplied software, Shuttle Xpress is
This balun is the perfect accessory to connect a long wire antenna, for example with the converter HF SDR Ham it Up to listen shortwave and HF bands from 0.5 to 30Mhz, but this balun can work up to
Cable SMA Male to SMA Male with 50-ohm coaxial cable low loss KSR195 for use from 0 to 6GHz.Length: 0,5m (50cm), 1, 3 or 5 metersConnector 1: SMA MaleConnector 2: SMA Male
Coaxial cable SMA Male to UHF Male with 50-ohm coaxial cable low loss KSR195 for use from 0 to 6GHz.Length: 1, 2, 5 or 10 metersConnector 1: SMA MaleConnector 2: UHF Male
New version of the SDRPlay wideband receiver, the RSP1A now covers all frequencies from 1 kHz to 2 GHz without hole, all modes, with up to 10 MHz bandwidth on the screen and 14-bit sampling. In
Optimized version of RTL-SDR.com, with R820T2 tuner for reception from 24 to 1766 MHz. The characteristics of the dongle RTL-SDR.com v3:- TCXO at 1 PPM (better stability and precision in frequencies)-
This band-cut filter is design by RTL-SDR.com, it blocks and reject broadcast FM band between 88 to 108 MHz with over 50dB of attenuation. Insertion loss is less than 0.5 dB between 0-1 GHz, and less
This high-pass notch filter is designed by RTL-SDR.com and rejects the AM broadcast from 500 kHz to 1.7 MHz, with attenuation of more than 50dB. In fact, because of the attenuation, the filter is
MLA-30 Plus magnetic loop active antenna for receiving HF bands from 500 kHz to 30 MHz.The MLA-30+ antenna can be used with the RTL-SDR V3 stick in direct conversion mode, with the Ham it up
Cliquez ici pour donner votre avis
Stock and shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal