2400 MHz 20W V3 SG LAB Amplifier for QO-100 View larger
SG LAB

SG-LAB-AMPLI-20W-1801

New product

Bulgaria

2400 MHz 20W V3 SG LAB Amplifier for QO-100 in SDR

rating No review at the moment

The SG LAB 2400 MHz V3 amplifier is intended to be used for amateur radio traffic on the QO-100 satellite and the 2.4 Ghz channel.

It allows to output up to 20W maximum from an input between 40mW and 100mW maximum.

  • LDMOS Transistor
  • 20W output power
  • High speed RF VOX
  • Preamplifier included
  • 30 dB power gain
  • Internal directional couplers with diode detectors at PA output
  • PTT switching: PTT is activated by connecting the PTT pin to ground
  • RF VOX is always on. The hold time can be set in the range 0-3sec by a built-in trimmer

This equipment is intended for amateur radio use only on the 13cm band.

Delivered with: 1 x 2.4GHz SG LAB amplifier, assembled and tested with soldered SMA connector.

More details

This material is no longer available

Download

Data sheet

TX output frequency: 2.38GHz to 2.42GHz
Input power: 40mW Max.
Output Power: 20W Max.
Power supply: 24V to 28V
Power consumption: 0.5A idle and 1.6A full power
PTT to ground (by optocoupler)
Connectors: SMA female
Dimensions: 82 x 57 x 19mm
Amateur radio design: LZ5HP - SG LAB
Warranty 2 years*

Reminder : This amplifier for QO-100 requires a minimum of knowledge in 2.4Ghz and the adequate measuring equipment to be used correctly. No refunds or returns will be given for amplifiers with burnt out PAs or loss of power.

* The warranty does not cover the PA and power loss, which may result from incorrect mounting, incorrect antenna setting (VSWR), incorrect maximum input power, shorted power supply or coaxial line, and electrostatic discharge damage.

Additional or similar equipment

  • RF Amplifier 2400 MHz 20dB Analog Devices CN0417

    The Analog Devices CN0417 is a small RF power amplifier, powered by micro-USB, optimized to operate on 2400 MHz with 100mW max, gain of 20-21dB max., with a integrated bandpass filter 2400 to

    69,00 € tax incl.

    57,50 €tax excl.

    In stock
  • PlutoSDR RX & TX 325 MHz - 3.8 GHz Full-Duplex - SDR QO-100 REV C

    The PlutoSDR (Adalm-Pluto) REV C is an open-source SDR receiver and transmitter covering frequencies from 325MHz to 3.8GHz in half and full-duplex with a bandwidth of 20Mhz in 12bits.Adalm-Pluto was

    359,00 € tax incl.

    299,17 €tax excl.

    In stock
  • 2.4 Ghz SAW Bandpass filter for QO100

    This bandpass filter for the 2.4 Ghz (13cm) allows to reject the local oscillator and harmonics frequencies of the Up-Converter for QO-100 to get a clean signal on the satellite, with a max. input

    25,90 € tax incl.

    21,58 €tax excl.

    In stock
  • DualBand Feed 2.4 & 10 GHz DJ7GP V2 Antenna with LNB Single / Twin

    This V2 version of DJ7GP's 2.4 / 10 Ghz dualband feed antenna is ready for use in RX and TX LHCP Circular Polarized for 2400 MHz and 10500 MHz reception for Oscar-100 satellite via LNB head climb.

    135,00 € tax incl.

    112,50 €tax excl.

    Out of stock, available in 2 weeks
  • Pack LNB PLL TCXO + BIAS-T for RX SDR or 432Mhz QO100

    The RemoteQTH Pack includes a LNB PLL head modified with TCXO and 25Mhz quartz, as well as a bias-T power supply with adjustable attenuation and available in 2 versions: With a SDR stick on 739Mhz and

    69,00 € tax incl.

    57,50 €tax excl.

    In stock
  • RF Amplifier 2400 MHz 100mW for QO-100 and Upconverter F1OPA

    This power amplifier equipment with a gain of 30dB is intended to operate primarily with F1OPA's upconverter 144 / 432Mhz - 2400 MHz to traffic on the QO-100 satellite uplink with 100mW output (20dBm)

    50,00 € tax incl.

    41,67 €tax excl.

    In stock
  • QO-100 TX Broadcast Pack in SDR with Adalm PlutoSDR + 100mW amp + filter

    The QO100 Adalm PlutoSDR pack includes the main elements for SDR transmission from a computer to the 2400 Mhz uplink channel of the QO-100 amateur radio satellite.The cables and adapters most commonly

    469,00 € tax incl.

    390,83 €tax excl.

    Out of stock, available in 3-4 weeks
  • RG402 rigid coaxial cable with SMA Male - SMA Male very low loss

    Very low loss coaxial cable with SMA Male connector on each end, for example to connect a 2.4Ghz amplifier to a transverter for OQ-100, or any use requiring a very low loss cable like the

    6,00 € tax incl.

    5,00 €tax excl.

    In stock
  • RG402 rigid coaxial with straight SMA Male and angled SMA Male

    Very low loss RG402 coaxial cable with  straight SMA Male and angled SMA Male, for example to connect a 2400 Mhz amplifier to a converter OQ-100, or any use requiring a very low loss cable. Coaxial

    6,50 € tax incl.

    5,42 €tax excl.

    Out of stock, available in 1 month
  • Coaxial cable RG-402 with SMA Male angled x2

    Very low loss RG-402 coaxial cable with angled SMA Male on both side, 50 ohms and with a length of 10cm. Note: This rigid cable can be bent but once installed in its position of use, the cable must

    7,00 € tax incl.

    5,83 €tax excl.

    In stock
  • Metal case for 2.4 Ghz MK2 DX Patrol QO-100 amplifier

    Metal case for the DX Patrol 2.4 Ghz MK2 (V2) amplifier for activity on the QO-100 ham radio satellite.Supplied with: 1 metal box for 2.4 Ghz DX Patrol amplifier.

    27,00 € tax incl.

    22,50 €tax excl.

    45,00 € -40%
    In stock
  • 2.4 Ghz variable gain pre-amplifier SG LAB

    Variable gain pre-amplifier with 15dBGain control in 1 dB stepsAdditional filtering for the 2.4 GHz bandPower supply 8-30 V DCOutput detector This equipment is intended for amateur radio use only on

  • SG Labs 13cm V1.4 Transverter 432-2400 MHz for QO-100

    The SG LABS 13cm v1.4 transverter for QO-100, allows transmitting from a 432 MHz UHF SSB station to 2400 MHz (13cm) on the uplink channel of the QO-100 satellite with a maximum output power of 2W.

  • ICOM IC-905 transceiver all modes 144 /430/1200/2400/5600 MHz + 10 GHz (option)

    VHF/UHF/SHF digital and analog amateur radio base IC-905, all modes coverage: 144/430/1200MHz (10W), 2400/5600MHz (2W) and 10GHz (0.5W) with CX-10G (optional). All modes: SSB, CW, AM, FM, D-STAR

    3 999,00 € tax incl.

    3 332,50 €tax excl.

    Expected to be available in summer 2023
  • 120cm tripod for satellite dish

    This tripod is a mobile support used for satellite dishes from 60 cm to 80 cm in diameter. The mast is adjustable up to 120 cm, and can be rotated in all directions. Made of lightweight and stable

    29,90 € tax incl.

    24,92 €tax excl.

    In stock

Reviews

Click here to leave a review


Delivery Europe & Overseas

Stock and shipped from France

Product return

14 days to return, 2 warranty

Email support

Response within 24h to 72h

Secure payment

SSL, VISA, Mastercard, Paypal