Viewed products
The mAT-125E is a universal automatic antenna...
-10,00 €
MTUNER-MAT-125E-1609
New product
China
Shenzhen Powertechning Technology Company (MAT-TUNER), Tian xia Creative Industral Park, 518000 Shenzhen, China, Tel. : +86 15503189053, mail: bg3mzu@gmail.com
Passion Radio, 117 rue de Charenton, 75012 Paris - France, Tel. +33(0)7.66.54.74.11, mail: support@passion-radio.com
The mAT-125E is a universal automatic antenna tuner that can be used in most HF transceivers.
It has a working frequency range of 1.6-54 MHz and a maximum permitted RF power of 120 watts.
It has built-in lithium batteries, does not require an external power supply and is very convenient to use, especially in portable outdoor applications.
The mAT-125E does not require a control cable to connect the transceiver. An RF cable is all that's needed to connect the transceiver for it to work properly.
It can be used to tune dipoles, verticals, Yagis, or virtually any coax-fed antenna.
Supplied with: 1 mAT-125E tuner and 1 usb cable
The mAT-125E has 16,000 frequency memories. When you tune to or near a previously set frequency, the mAT-125E uses "Memory Tune" to recall the previous tuning parameters in a fraction of a second. If no stored tuning is available, the tuner performs a full tuning cycle, storing the settings for memory recall on subsequent tuning cycles to that frequency.
In this way, the mAT-125E 'learns' as it goes along, adapting to bands and frequencies. You can also start a tuning cycle manually if required. The tuner has four fine-tuning buttons. After automatic tuning, you can make finer adjustments manually to achieve a lower SWR.
Two 18650 lithium batteries are fitted inside the mAT-125E, which power the tuner. Thanks to the use of advanced magnetic holding relays, the power consumption of the mAT-125E is very low, and the lithium battery can operate for a long time after it has been fully charged. It is highly suitable for outdoor use. Special chargers are supplied with tuners. You must use your own charger to charge the tuner. It is dangerous to charge with an incorrect charger.
Important note: When using in FT8/FT4 digital mode, or in AM or RTTY carrier mode, the maximum power must be reduced by at least half (30-40W max recommended), and when tuning the transmitter power must be at a minimum (5W), otherwise the tuner will burn out and this will not be covered by the warranty in the event of excessive power.
Reference: CORDON-RG58-UHF-M-30CM-1114
UHF Male - UHF Male (PL-259) coaxial cable with RG58 MIL-C-17 50 ohm connector for frequency use from 0 to 1000Mhz. Available in different lengths: 30cm, 50cm, 1m or 2 metres. Connector 1: UHF Male
Reference: KOM-EMBASE-BK-1500-539
This 15cm diameter magnetic base ensures a solid fixation and allows to screw a PL-259 antenna (UHF-male) on a car roof or a metal surface of minimum 1m².The magnetic base allows to support antennas
Reference: CABLE-COAXIAL-UHF-M-1M-876
UHF Male - UHF Male coaxial cable extension with KSR195 low-loss 50 ohm coaxial cable for use from 0 to 6 GHz. Available lengths: 50cm, 1, 2, 3, 5 or 10, 15 and 20 metresConnector 1: UHF Male
Reference: ADAPT-N-M-UHF-F-252
RF adapter for N male to UHF female connector (SO239). Impedance 50 ohms.
Reference: XIEGU-XPA125B-545
The Xiegu XPA125-B (new version) is a 100-125W amplifier for frequencies from 0.5 to 30Mhz and 50 to 54Mhz, with an integrated antenna tuner (1.8 to 30Mhz). It is equipped with protections:
Reference: XIEGU-G90-HAM-1013
The Xiegu G90 is a 20W portable HF amateur radio transceiver with a 24-bit SDR architecture, a built-in automatic antenna tuner, detachable display, 3cm (1.8 inch) high-brightness color TFT LCD
Reference: SIGNALINK-PACK-SLUSB6PM-1484
The Signalink SLUSB-6PM V2 interface pack is compatible with virtually all ICOM, Kenwood and Yaesu radios equipped with a 6-pin mini-DIN data port (DATA socket) such as: IC-706MKIIG, IC-9100, IC
Reference: SIGNALINK-PACK-SLUSB5PD-1515
The Signalink-SLUSB-5PD interface pack is compatible with Yaesu and Ten-Tec radios equipped with a 5-pin mini-DIN data port (DATA socket) such as: Yaesu FT1000, FT2000, FTDX5000, FTDX9000 (list
Click here to leave a review
Bon produit
Easy shopping and good selection..
Be the first to ask a question about this product!
The Xiegu X5105 V3* is a QRP portable HF+6M transceiver, SSB / CW / AM / FM / RTTY / PSK / FT8** modes, with a high-capacity 3800mAh battery, an integrated automatic antenna tuner, and a front-end
The Xiegu XPA125-B (new version) is a 100-125W amplifier for frequencies from 0.5 to 30Mhz and 50 to 54Mhz, with an integrated antenna tuner (1.8 to 30Mhz). It is equipped with protections:
579,17 €tax excl.
The Xiegu G90 is a 20W portable HF amateur radio transceiver with a 24-bit SDR architecture, a built-in automatic antenna tuner, detachable display, 3cm (1.8 inch) high-brightness color TFT LCD
437,50 €tax excl.
The Signalink SLUSB-6PM V2 interface pack is compatible with virtually all ICOM, Kenwood and Yaesu radios equipped with a 6-pin mini-DIN data port (DATA socket) such as: IC-706MKIIG, IC-9100, IC
157,50 €tax excl.
The Signalink-SLUSB-5PD interface pack is compatible with Yaesu and Ten-Tec radios equipped with a 5-pin mini-DIN data port (DATA socket) such as: Yaesu FT1000, FT2000, FTDX5000, FTDX9000 (list
149,17 €tax excl.
The Signalink-SLUSB-8PD interface pack is compatible with practically all ICOM and Ten-Tec radios equipped with an 8-pin mini-DIN data port (DATA socket) such as: ICOM IC-756, IC-7600 , IC-7610,
157,50 €tax excl.
The mAT-30 V2 is an automatic tuner designed for use with YAESU transceivers. It works with all YAESU transceivers that support a YAESU FC-30, FC-40 or FC-50 tuner. Frequency range: 1.6MHz to 54MHz
162,42 €tax excl.
209,00 €The mAT-10 is a compact tuner designed for use with the YAESU FT-817 and FT-818 transceivers and can also be used with other QRP transceivers. It can tune dipoles, verticals, Yagis, or virtually any
212,50 €tax excl.
The mAT-40 is an automatic HF/SSB tuner that lets you quickly tune any asymmetric or single-wire antenna automatically. Depending on the interface cable added (sold separately), it can work with Yaesu
240,83 €tax excl.
The mAT-180H is an automatic antenna tuner operating in the 1.8MHz to 54MHz range, at power levels up to 120 watts. It can be used to tune dipoles, verticals, Yagis, or virtually any coax-fed
157,50 €tax excl.
The mAT-K100 is an automatic antenna tuner operating in the 1.8MHz to 54MHz range, at power levels up to 120 watts. It can be used to tune dipoles, verticals, Yagis, or virtually any coax-fed
165,83 €tax excl.
209,00 €The mAT-705Plus automatic antenna tuner is designed for the Icom IC-705 transceiver and can operate in the 1.8MHz to 54MHz range. It is powered by two built-in lithium batteries, and can be charged by
204,17 €tax excl.
259,00 €The CHA Pocket OFCD is a 40m - 6m (7 to 54 MHz) multi-band HF antenna, WINDOM type, asymmetric dipole OCF (off-center-fed) and can fit in a pocket when not in use. This antenna is designed for
The Xiegu X6100 is an ultra portable HF/50MHz SDR transceiver for the HF amateur radio bands from 0 to 30MHz and the 6m band (50MHz), all modes (AM/FM/SSB) including DATA, with 10W maximum (on 12V
565,83 €tax excl.
ICOM AH-730 automatic tuner for HF bands from 1.8 to 54MHz (160m to 6m), 150W (PEP) and 100W (continuous), for ICOM transceivers IC-7300IC-707, IC-718, IC-7200, IC-725, IC-7400, IC-7410, IC-7610,
415,00 €tax excl.
The mAT-1500Pro V1 is a high-power, multi-function automatic antenna tuner, capable of adapting to almost any transmitter and amplifier. It is specifically designed to support a maximum RF power of
582,50 €tax excl.
The MAT TUNER mAT-1500ProII V2 is a versatile, high-power 1500 watt (SSB) automatic antenna tuner that can be adapted to almost any transmitter and linear amplifier in the 1.8 to 30 MHz frequency
707,50 €tax excl.
Shipped from France
14 days to return, 2 warranty
Response within 24h to 72h
SSL, VISA, Mastercard, Paypal
Copyright 2014-2025 - Passion Radio / 4 MY PEOPLE.
Les photos et coloris ne sont pas contractuels.