2.4 Ghz SAW Bandpass filter for QO100

Additional or similar equipment

• 

  LNA VHF UHF preamplifier with PGA-103 + for RF and SDR application

  The LNA4ALL is a pre-amplifier and a low-pass filter (LNA) with SMA female RF connectors and for RF frequencies covering all bands from 28MHZ to 2500 MHz. It improves greatly reception performance, on

  44,90 € tax incl.

  37,42 €tax excl.

  Material no longer available
• 

  Adapter SMA Male

  This RF adapter is fitted with a male SMA connector on both sides. It can be used to connect 2 SMA female cables or connectors, for example.

  4,50 € tax incl.

  3,75 €tax excl.

  In stock
• 

  Coaxial cable extension 1.2, 5 or 10m SMA Male and bare end (KSR195)

  Low-loss 50 ohm coaxial cable KSR195 5mm, for use from 0 to 6Ghz and with an SMA Male connector at one end and without connector at the other end (bare end to be soldered or crimped). Length:

  8,90 € tax incl.

  7,42 €tax excl.

  In stock
• 

  BIAS-TEE for QO-100 or LNA 30MHz to 4GHz F1OPA

  This BT4G-based BIAS-TEE with SMA female connector is used to power a LNA or a 10Ghz PLL LNB to receive the QO-100 / Es'Hail2 satellite.The BT4G covers the frequency bands from 30 MHz to 4 GHz. The

  17,50 € tax incl.

  14,58 €tax excl.

  In stock
• 

  POTY dual band feed antenna 2.4 Ghz & 10 Ghz for QO100 SMA or N connector

  The POTY (Patch Of The Year) antenna is a dual-band 2.4 GHz /10 GHz antenna, with left-hand circular polarization LHCP for 2400 MHz transmission and a linear horn antenna for 10500 MHz reception with

  69,00 € tax incl.

  57,50 €tax excl.

  Out of stock, available in 2-3 weeks
• 

  RF Amplifier 2400 MHz 20dB Analog Devices CN0417

  The Analog Devices CN0417 is a small RF power amplifier, powered by micro-USB, optimized to operate on 2400 MHz with 100mW max, gain of 20-21dB max., with a integrated bandpass filter 2400 to

  69,00 € tax incl.

  57,50 €tax excl.

• 

  Mixer up-converter 144/432Mhz to 2.4Ghz for QO-100 F1OPA

  This 144/432Mhz mixer to the 2.4GHz band is intended to be used as a dedicated up-converter to traffic on the uplink of the QO-100 satellite. The included SAW filter allows system size reduction as

• 

  1090 Mhz SAW Bandpass ADS-B filter F1OPA

  This ADS-B bandpass/cut filter for 1090Mhz allows to improve the performance and the selectivity of the signal in ADS-B reception and to suppress the signals outside the 1090Mhz band.Delivered with :

  27,90 € tax incl.

  23,25 €tax excl.

  In stock
• 

  LNA Wide Band 50-2500Mhz amplifier F1OPA

  Wide-band LNA preamp, based on PGA-103+, to improve reception performance from 50 Mhz to 1500 Mhz, with a maximum gain of 20-24dB and a noise factor of 0.4dB.This VHF-UHF LNA offers a very good

  37,80 € tax incl.

  31,50 €tax excl.

  In stock
• 

  Bandpass SAW Filter 868 Mhz for Helium LoRa Meshtastic Lorawan SigFox Zigbee

  This filter for the 868 MHz bandpass allows to improve the selectivity of the reception and to suppress the parasitic signals outside the 868MHz band and in particular to reject the GSM 900 MHz

  27,90 € tax incl.

  23,25 €tax excl.

  In stock
• 

  DualBand Feed 2.4 & 10 GHz DJ7GP V2 Antenna with LNB Single / Twin

  This V2 version of DJ7GP's 2.4 / 10 Ghz dualband feed antenna is ready for use in RX and TX LHCP Circular Polarized for 2400 MHz and 10500 MHz reception for Oscar-100 satellite via LNB head climb.

  135,00 € tax incl.

  112,50 €tax excl.

  In stock
• 

  Low-loss coaxial cable extension SMA Male angled & SMA straight KSR195 QO100

  KSR195 low-loss 50-ohm coaxial extension cable for use from 0 to 6Ghz, with angled SMA connector and straight male SMA connector.Available lengths: 50cm, 80cm, 1, 2, 5 and 10 meters Connector 1: SMA

  7,90 € tax incl.

  6,58 €tax excl.

  In stock
• 

  RF Amplifier 2400 MHz 100mW for QO-100 and Upconverter F1OPA

  This power amplifier equipment with a gain of 30dB is intended to operate primarily with F1OPA's upconverter 144 / 432Mhz - 2400 MHz to traffic on the QO-100 satellite uplink with 100mW output (20dBm)

  49,13 € tax incl.

  40,94 €tax excl.

  Out of stock, available in 2 to 3 weeks
• 

  Half aluminium case for PCB OPA Design

  This milled half aluminum box is specially designed for the RF protection of PCB's from F1OPA Design: LNA VHF-UHF, Bias-T, 2.4Ghz amplifier, SAW 868Mhz filters, ADS-B, QO-100 2.4Ghz and HF LNA.Case

  19,90 € tax incl.

  16,58 €tax excl.

  In stock
• 

  RG402 rigid coaxial cable with SMA Male - SMA Male very low loss

  Very low-loss coaxial cable with male SMA connector on each end, for connecting, for example, a 2.4 Ghz amp to an OQ-100 transverter, or any use requiring a very low-loss cable like the RG402. RG 402

  6,00 € tax incl.

  5,00 €tax excl.

  In stock
• 

  RG402 rigid coaxial with SMA Male straight and SMA Male angled

  Very low-loss RG-402 coaxial cable with a straight male SMA connector on one end and an angled SMA connector on the other. For connecting, for example, a 2400 MHz amplifier to an OQ-100 converter, or

  6,50 € tax incl.

  5,42 €tax excl.

  In stock
• 

  RG-402 coaxial cable with SMA Male angled x2

  RG-402 ultra-low-loss coaxial cable with male SMA connector angled on 2 sides, 50 ohm ultra-low-loss cable, 10 cm long. Note: This rigid cable can be bent, but once installed in its position of use,

  7,00 € tax incl.

  5,83 €tax excl.

  In stock
• 

  NanoVNA V2 VNA analyzer 50KHz to 3000MHz N or SMA plug + metal case

  The NanoVNA V2 SAA2N is an antenna and vector network (VNA) analyzer that covers the HF, VHF and UHF bands from 50 KHz to 3000 MHz, with N or SMA type connector and a metal case.It measures the

• 

  NANOVNA-F V2 3GHz Antenna Analyser 50kHz to 3000 MHz

  The NanoVNA-F V2 is a new-generation vector network analyser designed to be both portable and self-contained, with a wide range of features. The analyser is equipped with a 4.3" IPS LCD display, a

  195,00 € tax incl.

  162,50 €tax excl.

  In stock
• 

  1090 MHz ADS-B preamplifier with bandpass filter

  1090MHz ADS-B+LAN Bandpass Filter Module with Integrated Preamplifier High Performance Bandpass FilterSpecification :- Frequency range : 1G - 1.2GHz- Size : 105 x 45.7mmIncluded in the package :- 1 x

  8,93 € tax incl.

  7,44 €tax excl.

  14,88 € -40%

  Out of stock. Available within 1 to 2 months
• 

  CHELEGANCE JNCRADIO VNA 3G - 50kHz to 3GHz Aluminum case

  JNCRadio VNA 3G is a portable Vector Network Analyzer with frequency coverage 50kHz to 3GHz. Its a more advanced product built on top of the NanoVNA-F V2, with a much more powerful processor and new

  229,00 € tax incl.

  190,83 €tax excl.

  In stock
• 

  VNA SV4401A 4.4G 50kHz – 4.4GHz with 7” capacitive touchscreen & N connectors

  SV4401A is a handheld Vector Network Analyzer (VNA) with frequency range of 50kHz to 4.4GHz. It can be used for S11 and S21 measurements. The S21 dynamic range is 75 dB, while the S11 dynamic range is

  479,00 € tax incl.

  399,17 €tax excl.

  In stock
• 

  BPF 2m low-loss bandpass filter 144-148 MHz N plug 1500W (AA)

  Transmitter bandpass filter from Antennas Amplifiers for the 2m frequency band from 144 MHz to 148 MHz 1.5 kW, with insertion loss <0.1 dB, N female connector and maximum power 1500W. The BPF

  329,00 € tax incl.

  274,17 €tax excl.

  Available to order only, within 10 to 15 days
• Sale!

  Low-loss 70cm BPF bandpass filter N plug 200W 430-450 MHz (AA)

  Band-pass filter Antennas Amplifiers for transmitting on the 70cm amateur radio frequency band from 430 to 450 MHz, <0.12 dB with high selectivity, high Q and very low loss, designed for 200 W

  239,00 € tax incl.

  199,17 €tax excl.

  Available to order only, within 10 to 15 days
• 

  Upconverter Localino 2.4 GHz 5W QO-100 input 28/50/144/432 MHz VOX TCXO

  The new Upconverter-H from Localino and for QO-100 makes it quick and easy to get up and running on the QO100 satellite using an SSB transceiver in 28/50/144 or 432 MHz, with a maximum power of 5W on

  395,00 € tax incl.

  329,17 €tax excl.

  Out of stock, available in 3-4 weeks
• 

  Band-pass filter BPF band 6m 50-51 MHz N plug 1500W (AA)

  The Antennas Amplifiers BPF bandpass filter for the 6m "magic" band covers 50 to 51MHz with a maximum power of 1500W, a very low insertion loss of 0.11 dB and N plug connectors. Although this filter

  284,05 € tax incl.

  236,71 €tax excl.

  299,00 € -5%

  In stock
• 

  Pack MK3 LNB PLL TCXO + BIAS-T reception QO-100 10 GHz with 25MHz source

  The RemoteQTH 10 GHz LNB EXT OSC MK3 pack is an advanced system comprising an ultra-low-noise converter block and a Bias Tee, optimised for receiving 10 GHz satellite signals with exceptional

  169,00 € tax incl.

  140,83 €tax excl.

• 

  Adalm Pluto compatible 2.4 GHz 10W QO-100 amplifier

  13cm 2.4GHz amplifier for QO-100 compatible with the use of a Adalm Pluto to be operational on the QO-100 satellite in SDR with a maximum power of 10W on the 13cm 2.4 GHz band. With integrated TCXO,

  399,00 € tax incl.

  332,50 €tax excl.

• 

  LiteVNA64 VNA antenna analyser from 50KHz to 6.3GHz

  The LiteVNA64 is a touch-sensitive Vector Network Analyser (VNA) that offers advanced performance for HF, VHF, and UHF frequency testing, ranging from 50 KHz to 6.3 GHz. This is a significant upgrade

  219,00 € tax incl.

  182,50 €tax excl.

  Available to order within 2-3 weeks
• New Sale!

  2.4GHz TX 2.5W Max Bidirectional Amplifier + 10dB RX Preamp

  RigExpert's 2.4GPA power amplifier is designed to operate in the 2.0 to 2.6 GHz frequency band, including 2.4GHz frequencies. It can be used with an input power of 9-14.5 dBm (8-28mW) and a maximum

  249,00 € tax incl.

  207,50 €tax excl.

  259,00 €

  In stock